Wayne Dalton Garage Door Opener Programming

Programming a Wayne Dalton garage door opener is a relatively simple process that can be completed in a few minutes. By following the steps outlined below, you can easily program your opener to work with your remote control or keypad.

Step 1: Gather your materials

Before you begin, you will need to gather the following materials:

Your Wayne Dalton garage door opener
Your remote control or keypad
A ladder (if necessary)

Step 2: Locate the programming button

The programming button is typically located on the back or side of the garage door opener. It is usually a small, black button with the word "Program" or "Learn" printed on it.

Step 3: Press and hold the programming button

Press and hold the programming button for about 5 seconds. The LED light on the opener will begin to flash.

Step 4: Press the button on your remote control or keypad

Within 30 seconds of pressing the programming button, press the button on your remote control or keypad. The LED light on the opener will stop flashing and stay lit, indicating that the opener has been programmed.

Step 5: Test the opener

Once the opener has been programmed, test it to make sure it is working properly. Press the button on your remote control or keypad and the door should open or close.

Troubleshooting

If you are having trouble programming your Wayne Dalton garage door opener, there are a few things you can try:

Make sure that the batteries in your remote control or keypad are fresh.
Check the wiring connections on the opener to make sure they are secure.
Try resetting the opener by unplugging it for 30 seconds and then plugging it back in.

Additional tips

You can program up to 4 remote controls or keypads to your opener.
If you lose a remote control or keypad, you can easily delete it from the opener's memory by pressing and holding the programming button for 10 seconds.
For more information on programming your Wayne Dalton garage door opener, please refer to the user manual.