Rubber Seal On Garage Door

A rubber seal on a garage door is an essential component for keeping the elements out and maintaining the door's functionality. Over time, however, these seals can become damaged or worn, leading to drafts, leaks, and other problems. If you're experiencing issues with your garage door seal, it's important to inspect it and replace it if necessary.

There are a few different types of rubber seals used on garage doors, each with its own advantages and disadvantages. The most common type is the EPDM seal, which is made from ethylene propylene diene monomer. EPDM seals are durable, flexible, and resistant to UV rays and ozone. They are also relatively inexpensive, making them a good value for the money.

Another type of rubber seal is the neoprene seal, which is made from polychloroprene. Neoprene seals are even more durable than EPDM seals and are also resistant to oil and chemicals. However, they are more expensive than EPDM seals and can be more difficult to install.

Finally, there are silicone seals, which are made from silicone rubber. Silicone seals are the most expensive type of rubber seal, but they are also the most durable and resistant to extreme temperatures. They are also non-toxic and UV resistant, making them a good choice for areas with harsh weather conditions.

When choosing a rubber seal for your garage door, it's important to consider the following factors:

The type of material the seal is made from
The durability of the seal
The resistance of the seal to UV rays and ozone
The cost of the seal

Once you've considered these factors, you can choose the right rubber seal for your garage door and enjoy years of trouble-free operation.

How to Replace a Rubber Seal on a Garage Door

Replacing a rubber seal on a garage door is a relatively simple task that can be completed in a few hours. Here are the steps involved:

Gather your materials. You will need a new rubber seal, a utility knife, a screwdriver, and a hammer.
Remove the old rubber seal. Use the utility knife to cut the old seal away from the garage door. Be careful not to damage the door itself.
Clean the surface of the garage door. Remove any dirt or debris from the area where the new seal will be installed.
Apply the new rubber seal. Peel off the backing of the new seal and apply it to the garage door. Use the screwdriver to secure the seal in place.
Test the seal. Open and close the garage door to ensure that the seal is working properly.

By following these steps, you can replace the rubber seal on your garage door and keep the elements out.