Roll Up Garage Door Seals

Roll-up garage doors are a popular choice for many homeowners because they are affordable, easy to install, and require minimal maintenance. However, one of the most common problems with roll-up garage doors is that the seals around the door can become worn or damaged, allowing air and water to enter the garage. This can lead to a number of problems, including:

Increased energy costs
Drafts and cold spots in the garage
Water damage to the garage and its contents

Fortunately, replacing the seals on a roll-up garage door is a relatively simple and inexpensive task that can be completed in a few hours. Here are the steps on how to do it:

Gather your materials.

You will need the following materials to replace the seals on your roll-up garage door: * New seals * Measuring tape * Utility knife * Screwdriver * Caulk gun * Caulk 2.

Measure the door.

Use the measuring tape to measure the width and height of the door. You will need to purchase new seals that are the same size or slightly larger than the door. 3.

Remove the old seals.

Use the utility knife to carefully cut the old seals away from the door. Be careful not to damage the door itself. 4.

Clean the door.

Use a damp cloth to clean the door and remove any dirt or debris. This will help the new seals adhere properly. 5.

Apply the new seals.

Apply a bead of caulk to the back of the new seals. Then, press the seals into place on the door. Use the screwdriver to secure the seals in place. 6.

Caulk around the edges.

Once the seals are in place, apply a bead of caulk around the edges of the door. This will help to seal any gaps and prevent air and water from entering the garage. 7.