Reset Craftsman Garage Door Opener

If your Craftsman garage door opener isn't working properly, resetting it may be the solution. Resetting the opener will clear its memory and restore it to its factory default settings. This can resolve issues such as the door not opening or closing properly, the remote not working, or the safety sensors not functioning correctly.

Before you reset your Craftsman garage door opener, make sure that the power is turned off to the unit. To do this, locate the circuit breaker or fuse box that controls the power to the garage and turn it off. Once the power is off, you can proceed with the reset process.

Method 1: Using the Reset Button

Locate the reset button on the garage door opener. It is typically a small, red button located on the back or side of the unit.
Press and hold the reset button for at least 10 seconds. The opener will beep and the lights will flash to indicate that it has been reset.
Release the reset button and wait for the opener to complete its reset cycle. This may take a few minutes.
Once the reset cycle is complete, the opener will be restored to its factory default settings.

Method 2: Using the Remote Control

Press and hold the "Program" button on the remote control for at least 10 seconds. The remote will beep and the LED light will flash to indicate that it has been reset.
Release the "Program" button and wait for the remote to complete its reset cycle. This may take a few seconds.
Once the reset cycle is complete, the remote will be restored to its factory default settings.

Reprogramming the Garage Door Opener

After you have reset your Craftsman garage door opener, you will need to reprogram it to work with your remote control and safety sensors. To do this, follow the instructions provided in the owner's manual for your specific model of garage door opener.

Safety Precautions

Before you reset your Craftsman garage door opener, make sure that the door is closed and the safety sensors are aligned. If the safety sensors are not aligned, the door may not open or close properly, which could pose a safety hazard.