Reprogram Linear Garage Door Opener

Reprogramming a Linear garage door opener is a simple process that can be completed in a few minutes. By following the steps below, you can easily reprogram your opener to work with a new remote control or to change the security code. Before proceeding, make sure you have basic knowledge in electricity and familiarity with garage door working mechanisms. If you encounter any difficulties, contact a qualified electrician for assistance.

Tools and materials needed:

New remote control or keypad (optional)
Ladder
Screwdriver
Flashlight (optional)

Safety precautions:

Disconnect the power to the garage door opener before beginning any work.
Make sure the garage door is closed and the opener is in the "locked" position.
Wear safety glasses and gloves.

Step-by-step instructions:

Locate the control panel of the garage door opener. It is usually located on the ceiling of the garage, near the motor unit.
Open the control panel cover using the screwdriver.
Locate the "Program" button on the control panel. It is usually a small, black button.
Press and hold the "Program" button for 5 seconds. The LED light on the control panel will begin to flash.
Press the button on the new remote control or keypad. The LED light on the control panel will stop flashing and remain lit.
Repeat steps 4 and 5 for each additional remote control or keypad that you want to program.
Close the control panel cover and restore power to the garage door opener.
Test the new remote control or keypad to make sure that it is working properly.

Additional notes:

If you are having trouble programming the new remote control or keypad, try resetting the garage door opener to its factory default settings.
To reset the garage door opener, press and hold the "Program" button for 10 seconds. The LED light on the control panel will flash rapidly and then turn off.
After resetting the garage door opener, you will need to reprogram all of the remote controls and keypads that you want to use.