Replace Garage Door Torsion Spring

Torsion springs are a crucial component of the garage door system. They are responsible for counterbalancing the weight of the door, making it easier to lift and lower. Over time, however, torsion springs can wear out and need to be replaced. If you are experiencing difficulty opening or closing your garage door, it is possible that the torsion springs are to blame.

Replacing garage door torsion springs is a relatively complex task, but it is one that can be completed by a do-it-yourselfer with the right tools and safety equipment. Here is a step-by-step guide on how to replace garage door torsion springs:

1. Gather your tools and materials

New torsion springs
Safety glasses
Work gloves
Wrench set
Socket set
Tape measure
Level
Ladder
Hammer

2. Safety first

Before you begin working on your garage door, it is important to take some safety precautions. First, make sure that the door is in the closed position and that the power is disconnected. Next, put on your safety glasses and gloves. Finally, clear the area around the door of any obstacles.

3. Remove the old torsion springs

To remove the old torsion springs, you will need to first loosen the nuts that hold them in place. Once the nuts are loose, you can carefully remove the springs from the shaft. Be careful not to drop the springs, as they can be heavy and could cause injury.

4. Measure the old torsion springs

Once you have removed the old torsion springs, you will need to measure them so that you can purchase new springs of the same size. To measure the springs, use a tape measure to measure the length of the spring from end to end. You will also need to measure the diameter of the spring. Once you have the measurements, you can purchase new springs that are the same size as the old springs.

5. Install the new torsion springs

To install the new torsion springs, you will need to first insert them into the shaft. Once the springs are in place, you can tighten the nuts to hold them in place. Be sure to tighten the nuts evenly so that the springs are evenly tensioned.

6. Adjust the tension

Once the new torsion springs are installed, you will need to adjust the tension so that the door opens and closes smoothly. To do this, you will need to use a wrench to turn the adjusting bolts on the end of the torsion springs. Turn the bolts clockwise to increase the tension and counterclockwise to decrease the tension. You will need to experiment with the tension until you find the setting that works best for your door.

7. Test the door

Once you have adjusted the tension, you will need to test the door to make sure that it is working properly. To do this, simply open and close the door several times. The door should open and close smoothly without any jerking or binding.

8. Lubricate the door

Once you have tested the door and made sure that it is working properly, you should lubricate the door to keep it running smoothly. To do this, apply a lubricant to the hinges, rollers, and other moving parts of the door. You can use a spray lubricant or a grease lubricant. Be sure to follow the manufacturer's instructions for the lubricant that you choose.

9. Enjoy your new door

Once you have replaced the torsion springs and lubricated the door, you can enjoy your new garage door. The door should be easy to open and close and should provide years of trouble-free operation.