Replace Garage Door Extension Springs

Garage door extension springs are an essential part of the door's operation, providing the tension needed to lift and lower the door. Over time, these springs can wear out or break, making it difficult or impossible to open or close the door. If you find yourself in this situation, it's important to replace the springs as soon as possible to prevent further damage to your door or injury to yourself.

Replacing garage door extension springs is a relatively simple task that can be completed in a few hours with the right tools and materials. However, it's important to take safety precautions to avoid injury. Before you begin, gather the following materials:

New garage door extension springs
Wrench
Safety glasses
Gloves
Ladder

Once you have your materials, follow these steps to replace your garage door extension springs:

Safety first. Before you begin, disconnect the power to your garage door opener and engage the door's manual release mechanism.
Locate the springs. The extension springs are located on either side of the door, above the tracks. They are typically connected to the door with a bolt or a clevis pin.
Remove the old springs. Using a wrench, loosen the bolt or pin that connects the spring to the door. Once the spring is loose, carefully remove it from the door.
Install the new springs. Insert the new spring into the hole in the door and tighten the bolt or pin. Make sure that the spring is properly aligned with the door and that there is no slack in the spring.
Reconnect the door opener. Once the new springs are installed, reconnect the power to your garage door opener and disengage the manual release mechanism.
Test the door. Open and close the door several times to make sure that it is working properly.

If you have any questions or concerns about replacing your garage door extension springs, it is always best to consult with a qualified professional.