Program Remote Garage Door Opener Craftsman

Craftsman garage door openers are known for their reliability and durability. However, even the most reliable products can sometimes experience issues. If you're having trouble programming your Craftsman remote garage door opener, don't worry. This article will provide you with step-by-step instructions on how to program your remote so that you can get your garage door opener working properly again.

Before You Start

Before you begin programming your Craftsman remote garage door opener, there are a few things you'll need to do to prepare.

Make sure that you have a new battery installed in your remote.
Locate the Learn button on your garage door opener. It is usually located on the back or side of the unit.
Have your remote control handy.

Programming the Remote

Once you have prepared your materials, you can begin programming the remote.

Press and hold the Learn button on your garage door opener for 2 seconds. The LED light on the opener will start to flash.
Within 30 seconds, press and hold the button on your remote control that you want to program. The LED light on the opener will stop flashing and turn solid.
Release the button on your remote control.
Press the button on your remote control to test it. The garage door should open or close.

Troubleshooting

If you are having trouble programming your Craftsman remote garage door opener, there are a few things you can try:

Make sure that the battery in your remote control is fresh.
Make sure that you are pressing the Learn button on your garage door opener for the full 2 seconds.
Make sure that you are holding the button on your remote control for the full 30 seconds.
Try programming the remote from a different location.
Contact Craftsman customer service for assistance.

Conclusion

Programming a Craftsman remote garage door opener is a simple process that can be completed in just a few minutes. By following the steps in this article, you can easily get your garage door opener working properly again.