Program Linear Garage Door Opener

Garage door openers are a convenient way to open and close your garage door without having to get out of your car. Linear is one of the leading manufacturers of garage door openers, and their products are known for their reliability and durability. If you have a Linear garage door opener, you can program it yourself in a few simple steps.

What You'll Need

A Linear garage door opener
A ladder
A screwdriver
A remote control

Step-by-Step Instructions

1. Prepare the garage door opener. Before you begin programming your garage door opener, you need to prepare it. First, make sure that the power is turned off to the opener. Then, remove the cover from the opener. You will need to locate the programming button on the opener. The programming button is usually located on the back or side of the opener.

2. Press the programming button. Once you have located the programming button, press and hold it for five seconds. The LED light on the opener will start to flash.

3. Release the programming button. Once the LED light starts to flash, release the programming button.

4. Press the remote control button. Within 30 seconds of releasing the programming button, press the button on the remote control that you want to program.

5. The LED light will stop flashing. Once the LED light stops flashing, the remote control has been programmed.

6. Repeat steps 4 and 5 for additional remotes. If you want to program additional remotes, repeat steps 4 and 5 for each remote.

7. Replace the cover on the garage door opener. Once you have programmed all of the remotes, replace the cover on the garage door opener.

8. Turn on the power to the garage door opener. Once the cover is replaced, turn on the power to the garage door opener.

Troubleshooting

If you are having trouble programming your Linear garage door opener, there are a few things you can try:

Make sure that the power is turned off to the opener.
Make sure that the programming button is pressed for five seconds.
Make sure that the remote control button is pressed within 30 seconds of releasing the programming button.
Try using a different remote control.
Contact Linear customer service for assistance.