Program Chamberlain Garage Door Remote

Programming a Chamberlain garage door remote is a simple task that can be completed in a few minutes. By following these step-by-step instructions, you can easily program your remote to operate your garage door opener.

Materials Needed:

Chamberlain garage door remote
Ladder (if necessary)
Phillips screwdriver (if necessary)

Step-by-Step Instructions:

Locate the Learn Button: On the garage door opener motor unit, locate the "Learn" button. It is usually a small, round button with an LED light next to it.
Press and Hold the Learn Button: Press and hold the Learn button for 2-3 seconds until the LED light starts blinking.
Release the Learn Button: Once the LED light starts blinking, release the Learn button.
Position the Remote Close to the Motor Unit: Place the remote control near the garage door opener motor unit, within 1-2 feet.
Press and Hold the Remote Button: Press and hold the desired button on the remote control for 2-3 seconds.
Release the Remote Button: Once the LED light on the garage door opener motor unit stops blinking and remains solid, release the remote button.
Test the Remote: Walk to the garage door and press the button on the remote to test if it operates the door properly.

Additional Tips:

If you are programming a new remote, it is recommended to erase any existing codes before programming the new remote.
If you are having trouble programming the remote, check the batteries in the remote and make sure they are fresh.
If you are still having trouble programming the remote, refer to the user manual for your specific Chamberlain garage door opener model.

Safety Precautions:

Always follow the safety instructions provided in the user manual for your garage door opener.
Never attempt to program a remote while the garage door is in motion.
Keep the remote away from children and pets.