Installing Garage Door Weather Stripping Side And Top

Weather stripping is an essential component for any garage door, as it helps to seal out the elements and prevent heat loss. Over time, weather stripping can become worn or damaged, so it is important to inspect it regularly and replace it as needed. Installing weather stripping on the side and top of your garage door is a relatively easy task that can be completed in a few hours.

Materials You Will Need

* Weather stripping (foam, rubber, or vinyl) * Utility knife * Measuring tape * Scissors * Adhesive (optional)

Instructions

Measure the sides and top of your garage door.

Use a measuring tape to determine the length of the weather stripping needed. 2.

Cut the weather stripping to size.

Use a utility knife or scissors to cut the weather stripping to the desired length. 3.

Clean the surface of the garage door.

Remove any dirt or debris from the surface of the garage door where the weather stripping will be installed. 4.

Apply adhesive to the weather stripping (optional).

If you are using foam or rubber weather stripping, you can apply a thin layer of adhesive to the back of the weather stripping before installing it. This will help to keep the weather stripping in place. 5.

Install the weather stripping.

Start by installing the weather stripping on the sides of the garage door. Peel off the backing of the weather stripping and press it firmly into place along the edge of the garage door. 6.

Repeat step 5 for the top of the garage door.

Check the weather stripping for gaps.

Once the weather stripping is installed, check it for any gaps. If you find any gaps, you can fill them with caulk or expanding foam.

Tips

* Use a high-quality weather stripping that is resistant to UV rays and extreme weather conditions. * Make sure the weather stripping is the correct size for your garage door. If the weather stripping is too large, it will not seal properly. If the weather stripping is too small, it will not cover the entire gap. * Install the weather stripping in a warm, dry environment. This will help the adhesive to bond properly. * If you are not comfortable installing the weather stripping yourself, you can hire a professional to do it for you.