How To Wind A Garage Spring

A garage door spring is a torsion spring that helps to lift and lower the door. Over time, the spring can become weak or break, which can make it difficult or impossible to open or close the door. If you need to replace a garage door spring, it is important to do so safely and correctly. Here are the steps on how to wind a garage door spring:

1. Gather the necessary tools. You will need a pair of pliers, a screwdriver, and a pair of safety glasses. 2. Disconnect the power to the garage door opener. This will prevent the door from opening or closing while you are working on it. 3. Raise the garage door manually. To do this, pull the release cord that is located on the side of the door. 4. Locate the springs. The springs are located above the door on both sides. 5. Remove the old springs. To do this, use the pliers to remove the cotter pins that are holding the springs in place. Then, use the screwdriver to remove the screws that are holding the springs to the door. 6. Install the new springs. To do this, first place the springs on the door. Then, use the screws to attach the springs to the door. Finally, use the cotter pins to secure the springs in place. 7. Wind the springs. To do this, use the pliers to turn the winding cone on the end of the spring. Turn the cone until the spring is tight. 8. Reconnect the power to the garage door opener. Test the door to make sure that it opens and closes properly.

Tips:

Be careful when working with garage door springs. They can be dangerous if they are not handled properly.
If you are not comfortable working with garage door springs, it is best to call a professional.
Replace both springs at the same time, even if only one spring is broken. This will help to ensure that the door opens and closes evenly.
Lubricate the springs regularly to help them last longer.