How To Tighten Garage Door Springs

How to Tighten Garage Door Springs

Garage door springs are essential for the proper operation of your garage door. They provide the tension that allows the door to open and close smoothly. Over time, these springs can stretch and lose their tension, causing the door to become difficult to open or close. If you are experiencing this problem, you can tighten the garage door springs to restore their proper function.

Before you begin, it is important to take some safety precautions. Garage door springs are under a lot of tension, and if they are not handled properly, they can cause serious injury. Make sure to wear gloves and safety glasses when working on the springs. You should also disconnect the power to the garage door opener before starting work.

Once you have taken the necessary safety precautions, you can begin tightening the garage door springs. There are two types of garage door springs: extension springs and torsion springs. The type of spring that you have will determine the method that you use to tighten them.

Tightening Extension Springs

Extension springs are located on either side of the garage door. They are attached to the door frame at one end and to the door itself at the other end. To tighten extension springs, you will need to use a pair of pliers and a winding bar.

Insert the winding bar into the hole in the center of the spring.
Turn the winding bar clockwise to tighten the spring.
Continue turning the winding bar until the spring is tight enough that the door opens and closes smoothly.

Tightening Torsion Springs

Torsion springs are located above the garage door. They are attached to a shaft that runs parallel to the door. To tighten torsion springs, you will need to use a pair of pliers and a socket wrench.

Insert the socket wrench into the bolt that holds the spring in place.
Turn the socket wrench clockwise to tighten the bolt.
Continue turning the socket wrench until the spring is tight enough that the door opens and closes smoothly.

Once you have tightened the garage door springs, reconnect the power to the garage door opener and test the door to make sure that it is working properly. If the door is still difficult to open or close, you may need to adjust the tension on the springs further.