How To Reset Overhead Door Garage Door Opener

Resetting an overhead door garage door opener is a simple process that can be completed in a few minutes. By following these steps, you can easily reset your garage door opener and get it working properly again.

Step 1: Gather your materials.

You will need the following materials to reset your garage door opener:

A ladder
A Phillips head screwdriver
A new battery (if necessary)

Step 2: Locate the reset button.

The reset button is usually located on the back of the garage door opener motor unit. It is a small, red button that is recessed into the unit.

Step 3: Press and hold the reset button.

Use a Phillips head screwdriver to press and hold the reset button for 5 seconds. The motor unit will beep and the lights will flash.

Step 4: Release the reset button.

Release the reset button and wait for the motor unit to finish resetting. The lights will stop flashing and the motor unit will beep again.

Step 5: Test the garage door opener.

Press the button on the remote control to test the garage door opener. The door should open and close smoothly.

Step 6: Replace the battery (if necessary).

If the garage door opener does not work after resetting it, you may need to replace the battery. To do this, remove the battery cover on the back of the motor unit and replace the old battery with a new one.

Step 7: Reprogram the remote controls.

If you replaced the battery, you will need to reprogram the remote controls. To do this, follow the instructions in the owner's manual for your garage door opener.

By following these steps, you can easily reset your overhead door garage door opener and get it working properly again.