How To Reset A Garage Door Keypad

Garage door keypads are a convenient way to open and close your garage door without having to use a traditional key. However, if your keypad stops working, it can be frustrating. The good news is that resetting a garage door keypad is relatively easy. Here are the steps on how to do it:

Step 1: Gather Your Tools

You will need the following tools to reset your garage door keypad:

A Phillips head screwdriver
A new 9-volt battery

Step 2: Locate the Keypad

The keypad is usually located on the outside of your garage door. It is typically mounted on the wall next to the door.

Step 3: Remove the Keypad Cover

Use the screwdriver to remove the screws that hold the keypad cover in place. Once the screws are removed, lift the cover off of the keypad.

Step 4: Disconnect the Battery

Locate the battery connector on the back of the keypad. It is usually a small, black connector. Disconnect the battery connector from the keypad.

Step 5: Wait 30 Seconds

After you have disconnected the battery, wait 30 seconds. This will allow the keypad to reset itself.

Step 6: Connect the New Battery

Connect the new 9-volt battery to the keypad. Make sure that the positive terminal of the battery is connected to the positive terminal on the keypad. The negative terminal of the battery should be connected to the negative terminal on the keypad.

Step 7: Replace the Keypad Cover

Replace the keypad cover and tighten the screws.

Step 8: Test the Keypad

Enter your security code into the keypad. The garage door should open or close.

Tips

Here are a few tips for resetting your garage door keypad:

If you are unable to reset your garage door keypad, you may need to contact a professional.
It is important to replace the battery in your garage door keypad every year or two.
If you have any questions about resetting your garage door keypad, please refer to the owner's manual.