How To Reprogram Liftmaster Garage Door Keypad

If you need to reprogram your Liftmaster garage door keypad, there are a few steps that will guide you through the process. Here's what you need to do:

Step 1: Locate the Learn Button

The first step is to locate the Learn button on your Liftmaster garage door opener. This button is usually located on the back or side of the motor unit and looks like a small, black button.

Step 2: Press and Hold the Learn Button

Press and hold the Learn button for about 5 seconds, or until the LED light on the motor unit starts to flash. This indicates that the garage door opener is in programming mode.

Step 3: Enter the Programming Code

Next, you need to enter the programming code for your Liftmaster garage door opener. This code can be found on the back of the motor unit or in the owner's manual.

To enter the programming code, simply press the corresponding number buttons on the keypad. For example, if your programming code is 1234, you would press the 1 button, then the 2 button, and so on.

Step 4: Press the Enter Button

Once you have entered the programming code, press the Enter button on the keypad. The LED light on the motor unit should stop flashing and turn solid, indicating that the programming code has been successfully entered.

Step 5: Program the Keypad Buttons

Now you can program the keypad buttons to operate your garage door. To do this, simply press and hold the desired keypad button for about 5 seconds, or until the LED light on the motor unit starts to flash.

Then, press the corresponding button on the remote control that you want to program the keypad button to. The LED light on the motor unit should stop flashing and turn solid, indicating that the keypad button has been successfully programmed.

Step 6: Repeat for Additional Keypad Buttons

Repeat steps 5 for each additional keypad button that you want to program.

Step 7: Exit Programming Mode

To exit programming mode, simply press the Learn button on the motor unit again. The LED light on the motor unit should turn off, indicating that programming mode has been exited.