How To Reprogram A Keypad Garage Door Opener

A keypad garage door opener is a convenient way to open and close your garage door without having to use a remote control or key. However, if you need to reprogram the keypad, it can be a bit of a challenge. Here are the steps on how to reprogram a keypad garage door opener:

1. Gather your materials.

You will need the following materials:

A ladder
A screwdriver
The new keypad code

2. Locate the keypad.

The keypad is usually located on the outside of your garage door. It will be attached to the door with screws.

3. Remove the keypad.

Use the screwdriver to remove the screws that are holding the keypad in place. Once the screws are removed, you can pull the keypad away from the door.

4. Locate the programming button.

The programming button is usually located on the back of the keypad. It will be a small, black button.

5. Press the programming button.

Use a pen or pencil to press the programming button. Hold the button down for about 5 seconds. The keypad will beep and the LED light will start to flash.

6. Enter the new keypad code.

Use the keypad to enter the new keypad code. The new code can be any combination of numbers, from 1 to 99.

7. Press the enter button.

Once you have entered the new keypad code, press the enter button. The keypad will beep and the LED light will stop flashing.

8. Reinstall the keypad.

Align the keypad with the holes on the door. Insert the screws and tighten them until the keypad is secure.

9. Test the new keypad code.

Enter the new keypad code into the keypad. The garage door should open. If the garage door does not open, check to make sure that you entered the correct code.