How To Replace A Garage Door Bottom Seal

How to Replace a Garage Door Bottom Seal

The garage door's bottom seal is an essential part of sealing off the garage from the elements outside. This seal helps to keep out water, wind, and snow, while also preventing heat loss. Over time, the bottom seal can become worn or damaged, and this can result in a variety of problems, including water leaks, drafts, and increased energy costs. If you are experiencing any of these issues, it is important to replace the bottom seal as soon as possible.

Replacing the bottom seal is a relatively simple and inexpensive project that can be completed in a few hours. By following a few simple steps, you can save yourself time and money by doing the repair yourself.

Materials you will need:

New garage door bottom seal
Utility knife
Screwdriver
Measuring tape
Caulk gun
Caulk

Instructions:

1. Remove the old bottom seal. Use a utility knife to cut the old bottom seal along the length of the garage door. Be careful not to damage the door itself.

2. Clean the area where the new seal will be installed. Use a damp cloth to remove any dirt or debris from the area where the new seal will be installed.

3. Measure the length of the garage door. Use a measuring tape to measure the length of the garage door. Cut the new bottom seal to the same length.

4. Apply caulk to the bottom of the garage door. Use a caulk gun to apply a bead of caulk to the bottom of the garage door, along the length where the new seal will be installed.

5. Install the new bottom seal. Press the new bottom seal into place over the caulk bead. Use a screwdriver to secure the seal in place by screwing the provided screws through the seal and into the garage door.

6. Clean up. Use a damp cloth to clean up any excess caulk or debris.

By following these simple steps, you can easily replace the bottom seal on your garage door and keep your garage sealed off from the elements outside.