How To Program Liftmaster Garage Door Opener Keypad

Programming a LiftMaster garage door opener keypad is a straightforward process that can be completed in a few simple steps. By following these instructions, you can easily add or change the access codes for your garage door keypad, ensuring the security and convenience of your home.

Materials Required:

LiftMaster garage door opener keypad
Ladder or step stool
Phillips screwdriver

Instructions:

1. Remove the Keypad Cover:

Locate the keypad cover on the outside of your garage door. It is typically held in place by a few screws. Use a Phillips screwdriver to remove the screws and lift off the cover.

2. Locate the Programming Button:

Once the keypad cover is removed, you will see the keypad circuit board. Locate the programming button on the circuit board. It is usually a small, black button labeled "Prog" or "Program."

3. Enter Programming Mode:

Press and hold the programming button for approximately 5 seconds. The LED light on the keypad will start blinking, indicating that the keypad is now in programming mode.

4. Enter the Master Code:

Using the keypad, enter the master code for your garage door opener. The master code is typically a 4-digit number that was set during the initial installation of the opener.

5. Enter a New Access Code:

After entering the master code, the LED light on the keypad will stop blinking. Now, enter a new 4-digit access code that you want to use for the keypad.

6. Confirm the New Access Code:

Press the "#" key on the keypad to confirm the new access code. The LED light will blink once to indicate that the code has been successfully programmed.

7. Repeat for Additional Access Codes:

If you want to program additional access codes, repeat steps 5 and 6 for each new code.

8. Exit Programming Mode:

Once you have programmed all the desired access codes, press and hold the programming button again for approximately 5 seconds. The LED light will stop blinking, indicating that the keypad is now out of programming mode.

9. Replace the Keypad Cover:

Put the keypad cover back on and secure it with the screws. Make sure the cover is properly aligned and tightly secured.

Tip:

For added security, it is recommended to change the master code periodically, especially if you suspect that the code has been compromised.