How To Program Garage Door Keypad Liftmaster

LiftMaster garage door keypads are a convenient way to open and close your garage door without having to use a remote control or a key. They are easy to program and can be used with any LiftMaster garage door opener. Here are the steps on how to program a LiftMaster garage door keypad:

Gather your materials.

You will need the following items: * LiftMaster garage door keypad * Phillips head screwdriver * Ladder 2.

Prepare the keypad.

Remove the cover of the keypad by pressing on the two tabs on the bottom of the keypad and lifting the cover up. Then, remove the battery cover on the back of the keypad and insert a 9-volt battery. 3.

Mount the keypad.

Use the screws provided to mount the keypad to the wall next to your garage door. Make sure that the keypad is mounted at a height that is easy to reach. 4.

Connect the keypad to the garage door opener.

Open the access panel on the back of the garage door opener. Locate the two wires that are labeled "keypad." Connect the red wire from the keypad to the red wire on the garage door opener and the black wire from the keypad to the black wire on the garage door opener. 5.

Close the access panel.

Once the wires are connected, close the access panel on the back of the garage door opener. 6.

Program the keypad.

To program the keypad, you will need to enter the programming code for your garage door opener. The programming code is typically found on a sticker on the back of the garage door opener. If you cannot find the programming code, you can contact LiftMaster customer service. 7.

Enter the programming code.

To enter the programming code, press and hold the "Program" button on the keypad for 5 seconds. The LED light on the keypad will begin to flash. Enter the programming code using the number buttons on the keypad. The LED light will stop flashing when the programming code is entered correctly. 8.

Set the access code.

Once the programming code is entered, you can set the access code for the keypad. The access code can be any four-digit number. To set the access code, press and hold the "Set" button on the keypad for 5 seconds. The LED light on the keypad will begin to flash. Enter the access code using the number buttons on the keypad. The LED light will stop flashing when the access code is entered correctly. 9.

Test the keypad.

Once the access code is set, you can test the keypad by entering the access code and pressing the "Enter" button. The garage door should open. If the garage door does not open, check the connections between the keypad and the garage door opener.

Tips

* If you are having trouble programming the keypad, you can contact LiftMaster customer service for assistance. * You can change the access code for the keypad at any time by following the steps above. * You can add up to four different access codes to the keypad.