How To Install Garage Door Hinges

Garage door hinges are an essential part of any garage door system. They allow the door to open and close smoothly and securely. Over time, hinges can wear out and need to be replaced. Replacing garage door hinges is a relatively simple task that can be completed in a few hours.

Before you begin, gather the following tools and materials:

New garage door hinges
Drill
Screwdriver
Wrench
Hammer
Chisel
Safety glasses
Work gloves

Once you have gathered your tools and materials, follow these steps to install your new garage door hinges:

1. Safety First

Before you begin, put on your safety glasses and work gloves. Garage door hinges can be heavy, so it is important to take precautions to avoid injury.

2. Remove the Old Hinges

If you are replacing broken or worn hinges, begin by removing them. Using a chisel and hammer, remove the pins that hold the hinges in place. Once the pins have been removed, the old hinges can be removed.

3. Install the New Hinges

Place the new hinges in the same location as the old hinges. Using a drill, make pilot holes for the screws. Then, use a screwdriver to drive the screws into place.

4. Adjust the Hinges

Once the hinges have been installed, it is important to adjust them so that the garage door opens and closes smoothly. To adjust the hinges, loosen the screws that hold them in place. Then, move the hinges slightly until the door opens and closes properly. Once the hinges are adjusted, tighten the screws.

5. Test the Door

Once the hinges have been installed and adjusted, test the door to make sure that it opens and closes properly. If the door does not open or close smoothly, adjust the hinges until it does.

6. Lubricate the Hinges

To keep your garage door hinges working smoothly, it is important to lubricate them regularly. Use a spray lubricant to lubricate the hinges every few months.