How To Install A Garage Door Seal

Garage door seals are an important part of any garage door system. They help to keep out drafts, pests, and water, and they can also help to improve the energy efficiency of your home. If your garage door seal is damaged or worn, it's important to replace it as soon as possible. Installing a garage door seal is a relatively simple process that can be completed in a few hours.

Here are the steps on how to install a garage door seal:

Gather your materials. You will need a new garage door seal, a utility knife, a screwdriver, and a measuring tape.
Measure the length of your garage door. This will help you determine how long of a garage door seal you need to purchase.
Cut the garage door seal to the correct length. Use a utility knife to cut the garage door seal to the length that you measured in step 2.
Apply the garage door seal to the bottom of your garage door. Start by peeling off the backing of the garage door seal. Then, apply the seal to the bottom of your garage door, starting at one end and working your way to the other end.
Secure the garage door seal with screws. Once the garage door seal is in place, use a screwdriver to secure it with screws. Space the screws evenly along the length of the seal.
Test the garage door seal. Once the garage door seal is installed, test it by opening and closing your garage door. The seal should create a tight seal against the floor, and there should be no gaps or drafts.

By following these steps, you can easily install a garage door seal and improve the energy efficiency of your home.