How To Change The Garage Code

You've lost your garage door remote or the keypad stopped working, and you're wondering how to change the garage code. The process is actually quite simple and can be done in just a few minutes. Here are the steps on how to change the garage code:

1. Locate the garage door opener The garage door opener is usually mounted on the ceiling of the garage, near the door. It is a metal box with a motor and a gear that turns the door.

2. Open the garage door opener There is usually a small door on the front of the garage door opener. Open this door to access the controls.

3. Find the reset button The reset button is usually a small, red button located on the circuit board inside the garage door opener. Press and hold the reset button for 5 seconds.

4. Enter the new code After you have pressed the reset button, the garage door opener will be in programming mode. Enter the new code using the keypad. The code can be any combination of numbers, but it is best to use a code that is easy to remember.

5. Close the garage door opener Once you have entered the new code, close the door on the garage door opener.

6. Test the new code Use the keypad to enter the new code and open the garage door. If the door opens, then the new code has been successfully programmed.

Here are some additional tips for changing the garage code:

If you have a rolling code garage door opener, you will need to use a special remote to change the code. These remotes are available from the manufacturer of your garage door opener.
If you have a keypad that is not working, you may need to replace the keypad. Keypads are available from most hardware stores.
If you are having trouble changing the garage code, you can contact a professional garage door repairman.