How To Change Code On Genie Garage Door Opener

How to Change the Code on a Genie Garage Door Opener

If you need to change the code on your Genie garage door opener, there are a few different ways you can do it. The most common method is to use the learn button on the opener. This button is usually located on the back or side of the opener, and it will have a small light next to it. To change the code using the learn button, follow these steps:

Press and hold the learn button until the light next to it starts to flash.
Within 30 seconds, press the button on the remote control that you want to program.
The light on the opener will stop flashing, and the new code will be programmed.

You can also change the code on your Genie garage door opener using the keypad. To do this, follow these steps:

Enter the current code into the keypad.
Press the "Code" button.
Enter the new code into the keypad.
Press the "Enter" button.

If you have a Genie garage door opener that is equipped with a HomeLink system, you can also change the code using the HomeLink buttons. To do this, follow these steps:

Put the remote control for your garage door opener in the HomeLink compartment.
Press and hold the two outside HomeLink buttons until the LED light on the remote control starts to flash.
Release the buttons and press the "Program" button on the Genie garage door opener.
The LED light on the remote control will stop flashing, and the new code will be programmed.

Once you have changed the code on your Genie garage door opener, be sure to test it to make sure it is working properly. You should also make a note of the new code in a safe place.