How To Change Code On Garage Door Opener

Garage door openers can provide the convenience of being able to open and close your garage door without having to leave your vehicle. However, if you need to give access to your garage to someone else, or if you lose your remote, you may need to change the code on your garage door opener.

The process of changing the code on your garage door opener will vary depending on the model and brand of the opener, but there are some general steps you can follow.

Find the Learn Button

The first step is to locate the "learn" button on your garage door opener. This button is usually located on the back of the unit.

Press the Learn Button

Once you have found the learn button, press and hold it for a few seconds. The LED light on the opener will begin to flash.

Enter the New Code

While the LED light is flashing, enter the new code into the keypad on your remote control. Be sure to enter the code slowly and carefully.

Test the New Code

Once you have entered the new code, press the enter button or the button on your remote control to send the code to the opener. The LED light will stop flashing and the opener will beep.

Repeat for Additional Remotes

If you have multiple remotes, repeat the above steps for each remote that you want to program with the new code.

Tips

Here are a few tips to keep in mind when changing the code on your garage door opener:

Make sure that you are entering the correct code into the keypad.
If you make a mistake while entering the code, press the erase button on the keypad and start over.
Once you have changed the code, test it out to make sure that it is working properly.
Keep the new code in a safe place in case you need to use it again in the future.