How Do I Program A Genie Garage Door Opener

## How Do I Program A Genie Garage Door Opener?

Programming a Genie garage door opener is a relatively straightforward process that can be completed in a few simple steps. By following the instructions outlined below, you can easily program your Genie garage door opener to work with your existing remote controls or keypads.

Gather the necessary equipment.

To program your Genie garage door opener, you will need the following equipment:

Genie garage door opener
Remote control or keypad
Ladder
Screwdriver

Prepare the garage door opener.

Before you can begin programming your Genie garage door opener, you need to prepare it by completing the following steps:

Unplug the garage door opener from the power outlet.
Open the cover of the garage door opener using a screwdriver.
Locate the programming button on the circuit board. The programming button is usually located near the center of the circuit board and is labeled "Prog" or "Program."

Enter programming mode.

To enter programming mode, press and hold the programming button for 5 seconds. The LED light on the circuit board will begin to flash rapidly, indicating that the garage door opener is in programming mode.

Program the remote control or keypad.

To program the remote control or keypad, press and hold the desired button on the remote control or keypad for 5 seconds. The LED light on the circuit board will stop flashing and remain lit, indicating that the remote control or keypad has been successfully programmed.

Repeat for additional remotes or keypads.

If you have multiple remotes or keypads that you want to program, simply repeat steps 4 and 5 for each additional remote or keypad.

Exit programming mode.

To exit programming mode, press and release the programming button. The LED light on the circuit board will turn off, indicating that the garage door opener is no longer in programming mode.

Close the cover of the garage door opener.

Once you have finished programming your Genie garage door opener, close the cover of the garage door opener and secure it using the screwdriver.

Plug the garage door opener back into the power outlet.

Plug the garage door opener back into the power outlet to complete the programming process.

Test the garage door opener.

Once the garage door opener is plugged back into the power outlet, test it by pressing the button on the remote control or keypad. The garage door should open and close smoothly.