How Do I Change My Garage Door Code

How Do I Change My Garage Door Code?

Changing the code on your garage door is a relatively simple process that can be completed in a few minutes. However, it is important to note that the steps involved may vary depending on the make and model of your garage door opener. Here are the general steps on how to change your garage door code:

1. Locate the Learn Button

The learn button is typically located on the back or side of the garage door opener motor unit. It is usually a small, round button that is red, green, or yellow.

2. Press and Hold the Learn Button

Press and hold the learn button for about 5 seconds. The LED light on the opener will start to flash.

3. Enter the New Code

While the LED light is flashing, enter the new four-digit code you want to use. You can use the keypad on the opener or a remote control to enter the code.

4. Press the Enter Button

Once you have entered the new code, press the enter button on the opener. The LED light will stop flashing.

5. Test the New Code

Try using the new code to open and close the garage door. If the code works, the door will open and close smoothly. If the code does not work, repeat steps 2-4.

Additional Tips

If you are having trouble changing the code on your garage door opener, refer to the user manual for your specific model.
It is a good idea to change the code on your garage door opener regularly, especially if you have given the code to someone else.
If you have lost the user manual for your garage door opener, you can usually find a copy online by searching for the make and model of the opener.