Genie Garage Opener Learn Button

The Genie garage door opener learn button is a small, typically black button located on the motor unit of the opener. It is used to program the opener to recognize and respond to the remote controls and keypads that you will be using to operate the door.

To program a new remote or keypad to your Genie garage door opener, you will need to press and hold the learn button until the LED light on the motor unit starts to flash. Then, press the button on the remote or keypad that you want to program. The LED light will stop flashing and the opener will now be programmed to recognize that remote or keypad.

You can program up to four remotes or keypads to a single Genie garage door opener. If you need to program more than four remotes or keypads, you will need to purchase a Genie universal remote control or keypad.

Here are some additional tips for programming a Genie garage door opener learn button:

Make sure that the batteries in the remote or keypad are fresh.
Hold the remote or keypad close to the learn button when programming it.
If the LED light on the motor unit does not start to flash when you press the learn button, try pressing and holding the button for a longer period of time.
If you are having difficulty programming a remote or keypad to your Genie garage door opener, you can contact Genie customer service for assistance.

In addition to programming remotes and keypads, the Genie garage door opener learn button can also be used to reset the opener to its factory default settings. To do this, press and hold the learn button for 10 seconds. The LED light on the motor unit will flash rapidly and then turn off. The opener will now be reset to its factory default settings.