Genie Garage Door Opener Remote Programming

Programming a Genie garage door opener remote is a relatively straightforward process that can be completed in just a few minutes. By following the steps outlined below, you can easily program your remote to operate your Genie garage door opener.

Materials Needed:

* Genie garage door opener remote * Genie garage door opener * Ladder (if necessary)

Step 1: Locate the Learn Button

The first step is to locate the Learn button on your Genie garage door opener. The Learn button is typically located on the back or side of the opener unit. It may be covered by a small rubber cap.

Step 2: Press and Release the Learn Button

Once you have located the Learn button, press and release it. The LED light on the opener should begin to flash.

Step 3: Position the Remote Near the Opener

Position the Genie garage door opener remote near the opener unit. The remote should be within 1-2 feet of the opener.

Step 4: Press and Hold the Remote Button

Press and hold the button on the remote that you want to program. The LED light on the remote should begin to flash.

Step 5: Release the Remote Button

Once the LED light on the remote has stopped flashing, release the remote button.

Step 6: Test the Remote

To test the remote, press the button that you programmed. The garage door should open or close.

Troubleshooting:

* If the remote does not program, try repeating steps 2-6. * If the remote still does not program, check the batteries in the remote. * If the remote still does not program, contact Genie customer support.

Additional Tips:

* You can program up to three remotes to a single Genie garage door opener. * If you lose a remote, you can easily program a new one by following the steps above. * To erase all programmed remotes from your Genie garage door opener, press and hold the Learn button for 10 seconds.