Garage Door Spring Winding Bars

Garage door springs are essential for the safe and smooth operation of your garage door. They provide the tension needed to lift the door, and they also help to prevent the door from slamming shut. However, over time, garage door springs can lose their tension, which can make it difficult to open or close the door. If you notice that your garage door is becoming harder to open or close, it may be time to adjust the tension on the springs.

Garage door spring winding bars are a tool that can be used to adjust the tension on garage door springs. These bars are typically made of steel or aluminum, and they have a hook on one end that is used to attach to the spring. The other end of the bar has a handle that is used to turn the bar and wind the spring.

To use a garage door spring winding bar, first identify the springs that need to be adjusted. The springs are typically located on either side of the garage door, and they are attached to the door frame and the spring drum. Once you have identified the springs, attach the hook of the winding bar to one of the springs. Then, turn the handle of the bar to wind the spring. As you wind the spring, the tension on the spring will increase. Continue winding the spring until the desired tension is achieved.

Once you have adjusted the tension on one spring, repeat the process for the other spring. It is important to adjust the tension on both springs evenly, so that the door opens and closes smoothly. If you overwind one of the springs, it can cause the door to bind or jam. If you underwind one of the springs, it can cause the door to sag or fall.

Garage door spring winding bars are a simple and effective tool that can be used to adjust the tension on garage door springs. By following these instructions, you can safely and easily adjust the tension on your garage door springs and ensure that your door opens and closes smoothly.

Safety Precautions

When using a garage door spring winding bar, it is important to take some safety precautions. First, always wear safety glasses and gloves when working with garage door springs. Second, never attempt to adjust the tension on a spring that is under tension. Third, always use a winding bar that is the correct size for the springs that you are adjusting. Fourth, never overwind a spring. If you are not sure how to adjust the tension on a garage door spring, it is best to consult with a professional.

Clopay Commercial Spring Winding Bars 5686901 The Home

Winding Bars Pair 24 Hex With 5 8 1 2 Ends Part Wb 24h

Garage Door Torsion Spring Winding Bars Set Of Two 2 18 Inches Ebay

2 Pack 18 Inch Winding Rods For Garage Torsion Springs Repair Replacement 0 5inch Diameter Steel Bars Adjusting Or Replacing Door Tension With Rubber Handle And Sliding Hardware