Garage Door Opener Spring Broken

Garage door springs are an essential part of a garage door system, as they counterbalance the weight of the door and make it easy to open and close. However, over time, springs can wear out or break, which can lead to the door becoming inoperable.

There are two main types of garage door springs: torsion springs and extension springs. Torsion springs are mounted above the door and are wound around a shaft, while extension springs are mounted on either side of the door and stretch when the door is opened.

If you suspect that your garage door spring is broken, there are a few signs to look for. First, the door may be difficult to open or close, and it may make a grinding noise. Second, the door may not stay open when you release it, and it may fall back down. Finally, you may see a broken spring or pieces of metal on the ground near the door.

If you think that your garage door spring is broken, it is important to call a qualified garage door repair technician to have it fixed. Attempting to repair a broken spring yourself can be dangerous, as the springs are under a lot of tension.

The cost of replacing a garage door spring will vary depending on the type of spring and the cost of labor in your area. However, you can expect to pay between $100 and $300 for a new spring and installation.

To help prevent your garage door springs from breaking, it is important to keep them lubricated and to avoid slamming the door open or closed. You should also have your garage door inspected by a qualified technician once a year to ensure that all of the components are in good working order.

By following these tips, you can help extend the life of your garage door springs and keep your door operating smoothly for years to come.

Steps to Replace Garage Door Opener Spring

If you are replacing a broken garage door opener spring, it is important to follow these steps to ensure that the job is done safely and correctly.

Disconnect the garage door opener. This will prevent the door from opening or closing while you are working on it.
Support the door. Use a jack stand or a pair of sawhorses to support the door in the open position.
Identify the broken spring. The broken spring will be the one that is not attached to the door or the shaft.
Remove the broken spring. Use a pair of pliers to remove the cotter pins that hold the spring in place. Then, carefully remove the spring from the shaft or the door.
Install the new spring. Slip the new spring onto the shaft or the door, and then secure it with the cotter pins.
Reconnect the garage door opener. Once the new spring is installed, reconnect the garage door opener and test the door to make sure that it is working properly.

If you are not comfortable replacing a garage door spring yourself, it is important to call a qualified garage door repair technician to do the job for you.