Garage Door Extension Springs Replacement

Garage Door Extension Springs Replacement

Extension springs are one of the most important components of a garage door system. They are responsible for counterbalancing the weight of the door, making it easier to open and close. Over time, extension springs can wear out and need to be replaced. If you are experiencing any problems with your garage door, such as difficulty opening or closing it, it is possible that your extension springs need to be replaced.

Replacing garage door extension springs is a relatively simple task that can be completed in a few hours. However, it is important to take safety precautions when working on your garage door. Always disconnect the power to the door before starting any work, and be sure to wear safety glasses and gloves.

Step 1: Gather your tools and materials

Before you begin, you will need to gather the following tools and materials:

*

New extension springs (two per door)

*

Spring winding bars

*

Safety glasses

*

Gloves

*

Wrench

*

Socket wrench

*

Hammer

*

Drill

*

Screwdriver

Step 2: Disconnect the power to the garage door

Before starting any work on your garage door, it is important to disconnect the power to the door. This will prevent the door from opening or closing while you are working on it.

*

Locate the circuit breaker or fuse box for your garage door.

*

Turn off the circuit breaker or remove the fuse.

Step 3: Remove the old extension springs

Once the power to the garage door is disconnected, you can begin removing the old extension springs.

*

Open the garage door about halfway.

*

Locate the extension springs on either side of the door.

*

Use a spring winding bar to compress the spring.

*

Once the spring is compressed, use a wrench to loosen the nuts that hold the spring in place.

*

Remove the old extension springs.

Step 4: Install the new extension springs

Once the old extension springs are removed, you can install the new springs.

*

Place the new extension springs on the door.

*

Use a spring winding bar to compress the spring.

*

Once the spring is compressed, use a wrench to tighten the nuts that hold the spring in place.

*

Repeat this process on the other side of the door.

Step 5: Reconnect the power to the garage door

Once the new extension springs are installed, you can reconnect the power to the garage door.

*

Turn on the circuit breaker or replace the fuse.

*

Test the garage door to make sure it is working properly.

Safety tips

When working on your garage door, it is important to take safety precautions.

*

Always wear safety glasses and gloves.

*

Disconnect the power to the door before starting any work.

*

Be careful when handling the extension springs. They can be under a lot of tension and can cause serious injuries if they are not handled properly.

*

If you are not comfortable working on your garage door, it is best to call a qualified technician.

Ideal Security Garage Door Spring 140 Lb Dark Blue 2 Pack With Safety Cables

Ideal Security Grarage Door Extension Spring And Safety Cable 180 Lb Orange 2 Pack Sk7159p2v2

How To Replace Garage Broken Door Extension Spring Safety And Pulley Cables Step By

How To Replace Garage Door Extension Springs

Replace Garage Door Extension Springs With These Tips

Replace A Garage Door Extension Spring Youtube

Torsion Spring Systems Princeton Paramus Doors Done Right

Dura Lift 120 Lb Heavy Duty Extension Garage Door Spring 2 Pack Dlegr120

Garage Door Spring Repair Canadian

Replace Garage Door Extension Springs With These Tips