Garage Door Coil Spring Replacement

Garage door coil springs are an essential part of your garage door system, providing the tension needed to lift and lower the door smoothly and safely. Over time, these springs can wear out or break, requiring replacement. Replacing garage door coil springs is a serious task that should be performed by a qualified professional. However, if you are comfortable working with tools and have some mechanical experience, you may be able to replace them yourself. Here is a step-by-step guide to help you safely replace your garage door coil springs:

Safety First

Before you begin, it is important to take some safety precautions. Garage door springs are under a lot of tension, and if not handled properly, they can cause serious injury. Always wear safety glasses and gloves when working with garage door springs. Also, be sure to disconnect the garage door opener before you start working on the springs.

Gather Your Tools and Materials

You will need the following tools and materials to replace your garage door coil springs:

New garage door coil springs
Safety glasses
Gloves
Wrench
Socket set
Ladder

Step-by-Step Instructions

1. Remove the Old Springs

Start by removing the old garage door coil springs. To do this, first locate the safety cables that are attached to the springs. These cables help to prevent the springs from flying off if they break. Disconnect the safety cables from the springs, and then carefully remove the springs from the door.

2. Install the New Springs

Once the old springs are removed, you can install the new springs. Start by attaching the new springs to the door. Then, connect the safety cables to the springs. Finally, tighten the bolts that hold the springs in place.

3. Adjust the Tension

Once the new springs are installed, you need to adjust the tension. To do this, use a wrench to turn the adjusting bolts on the springs. Turn the bolts until the door opens and closes smoothly without binding.

4. Reconnect the Garage Door Opener

Once the tension is adjusted, you can reconnect the garage door opener. Be sure to follow the manufacturer's instructions for reconnecting the opener.

5. Test the Door

Once the garage door opener is reconnected, test the door to make sure it is working properly. Open and close the door several times to make sure it moves smoothly and without binding.

Tips

If you are not comfortable replacing garage door coil springs yourself, it is best to hire a qualified professional.
Always wear safety glasses and gloves when working with garage door springs.
Disconnect the garage door opener before you start working on the springs.
Be sure to follow the manufacturer's instructions for replacing your garage door coil springs.