Garage Door Broken Spring Replacement

A broken garage door spring is a common problem that can be easily fixed with the right tools and materials. Follow these step-by-step instructions to replace a broken garage door spring:

Step 1: Safety First

Before you start working on your garage door, make sure to disconnect the power to the opener. This will prevent the door from accidentally opening or closing while you're working on it.

Step 2: Remove the Old Spring

Locate the broken spring and remove the cotter pins that are holding it in place. Use a pair of pliers to carefully remove the spring from the brackets.

Step 3: Install the New Spring

Position the new spring into the brackets and secure it with the cotter pins. Make sure the spring is properly seated in the brackets before you reconnect the power.

Step 4: Adjust the Tension

Use a winding bar to adjust the tension on the spring. The tension should be tight enough to hold the door open, but not so tight that it makes it difficult to open or close.

Step 5: Test the Door

Reconnect the power to the opener and test the door. Make sure the door opens and closes smoothly and that there are no unusual noises.

Step 6: Clean Up

Once the door is working properly, clean up any debris and tools that you used during the repair.

Tips:

If you're not comfortable replacing a garage door spring yourself, call a professional to do it for you.
Garage door springs are under a lot of tension, so it's important to be careful when working with them.
Always wear gloves and safety glasses when working on your garage door.