Fix Broken Garage Door Spring

Garage door springs are an essential part of the system, as they help to counterbalance the weight of the door and make it easier to open and close. If a spring breaks, it can make the door difficult or impossible to operate. Fortunately, fixing a broken garage door spring is a relatively simple process that can be completed in a few hours.

Safety First

Before you begin, it is important to take some safety precautions. Garage door springs are under a lot of tension, so it is important to wear safety glasses and gloves when working on them. You should also disconnect the power to the garage door opener before starting work.

Tools and Materials

To fix a broken garage door spring, you will need the following tools and materials:

Safety glasses
Gloves
Wrench
Socket wrench
New garage door spring
Spring winding tool

Step-by-Step Instructions

Once you have gathered your tools and materials, you can follow these step-by-step instructions to fix the broken garage door spring:

Disconnect the power to the garage door opener. This is important for safety reasons, as you will be working near electrical wires.
Identify the broken spring. There are two springs on most garage doors, one on each side. The broken spring will be the one that is sagging or has visible damage.
Remove the broken spring. Use a wrench to loosen the bolts that hold the spring in place. Once the bolts are loose, you can carefully remove the spring from the door.
Install the new spring. Place the new spring on the door and tighten the bolts. Make sure that the spring is properly aligned and that it is not twisted.
Wind the spring. Use a spring winding tool to wind the new spring. This will create tension on the spring and make it easier to open and close the door.
Reconnect the power to the garage door opener. Once the spring is wound, you can reconnect the power to the garage door opener. Test the door to make sure that it is working properly.

Tips for Winding a Garage Door Spring

Winding a garage door spring can be a bit tricky, but it is important to do it correctly to ensure that the door operates smoothly. Here are a few tips:

Use a spring winding tool. This will make the job much easier and safer.
Wind the spring evenly. Do not overwind or underwind the spring.
Test the door after winding the spring. Make sure that the door opens and closes smoothly.