Change Out Garage Door Springs

Garage door springs are an essential part of your garage door system. They help to lift and lower the door, and they also provide tension to keep the door in place. Over time, springs can wear out and need to be replaced. If you're not sure how to change out garage door springs, don't worry! This article will provide you with step-by-step instructions on how to do it safely and easily.

Step 1: Gather Your Tools and Materials

Before you start, you'll need to gather a few tools and materials. These include:

New garage door springs
Wrenches
Socket set
Safety glasses
Gloves

Once you have all of your tools and materials, you're ready to begin.

Step 2: Disconnect the Garage Door Opener

The first step is to disconnect the garage door opener. This will prevent the door from opening or closing while you're working on it. To disconnect the opener, simply unplug it from the outlet.

Step 3: Secure the Garage Door

Once the opener is disconnected, you need to secure the garage door in the closed position. This will prevent it from falling down while you're working on it. To secure the door, simply insert a wedge or block of wood under the bottom of the door.

Step 4: Remove the Old Springs

Now it's time to remove the old springs. To do this, you'll need to use a wrench to loosen the nuts that hold the springs in place. Once the nuts are loose, you can carefully remove the springs.

Step 5: Install the New Springs

Once the old springs are removed, you can install the new springs. To do this, simply reverse the steps that you used to remove the old springs. First, insert the new springs into the brackets. Then, tighten the nuts that hold the springs in place.

Step 6: Adjust the Tension

Once the new springs are installed, you need to adjust the tension. To do this, you'll need to use a socket set to turn the bolts that adjust the tension. Turn the bolts clockwise to increase the tension, and turn them counterclockwise to decrease the tension.

Step 7: Reconnect the Garage Door Opener

Once the tension is adjusted, you can reconnect the garage door opener. To do this, simply plug the opener back into the outlet. Once the opener is plugged in, test the door to make sure that it opens and closes smoothly.

Conclusion

Changing out garage door springs is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can safely and easily replace your old springs with new ones.