Change Code On Garage Door Keypad

If you need to change the code on your garage door keypad, you can follow these steps:

Locate the "Learn" button on the keypad. It is usually a small button, often red or green, located near the bottom of the keypad.
Press and hold the "Learn" button for a few seconds until the LED on the keypad starts to flash.
Enter the old access code using the keypad.
Press the "*" button on the keypad.
Enter the new access code using the keypad.
Press the "#" button on the keypad.
The LED on the keypad will stop flashing, indicating that the new code has been programmed.

Here are some additional tips for changing the code on your garage door keypad:

Make sure that you have the correct access code before you start the process.
Be sure to enter the new access code twice, exactly the same both times.
If you make a mistake, you can press the "Clear" button on the keypad to start over.
Once you have successfully changed the code, test it to make sure that it works properly.

If you have any problems changing the code on your garage door keypad, you can refer to the user manual for your specific model or contact the manufacturer for assistance.

Here are some additional security tips for your garage door keypad: