Chamberlain Garage Opener Learn Button

The Chamberlain garage opener learn button is a small, black button located on the back of the motor unit. It is used to program new remotes and keypads to work with the opener. To program a new remote, first press the learn button on the back of the motor unit. Then, press and hold the button on the remote that you want to program. The LED light on the remote will begin to flash. Once the LED light stops flashing, the remote has been programmed successfully.

To program a new keypad, first press the learn button on the back of the motor unit. Then, enter the four-digit code that you want to use to open the garage door. The LED light on the keypad will begin to flash. Once the LED light stops flashing, the keypad has been programmed successfully.

If you need to reset the learn button, simply press and hold it for 10 seconds. This will clear all of the programmed remotes and keypads from the opener's memory.

Here are some additional tips for using the Chamberlain garage opener learn button:

Make sure that the remote or keypad is within 20 feet of the motor unit when you are programming it.
If the LED light on the remote or keypad does not flash when you press the learn button, it may be because the batteries are low. Replace the batteries and try again.
If you are having trouble programming a remote or keypad, you can contact Chamberlain customer service for assistance.

The Chamberlain garage opener learn button is a convenient and easy way to program new remotes and keypads to work with your opener. By following these simple steps, you can ensure that your garage door opener is working properly and securely.

Troubleshooting the Chamberlain Garage Opener Learn Button

If you are having trouble programming a new remote or keypad to your Chamberlain garage opener, there are a few things you can try:

Make sure that the remote or keypad is within 20 feet of the motor unit when you are programming it. The signal from the remote or keypad may not be strong enough to reach the motor unit if it is too far away.
If the LED light on the remote or keypad does not flash when you press the learn button, it may be because the batteries are low. Replace the batteries and try again.
Try resetting the learn button. To do this, simply press and hold the learn button for 10 seconds. This will clear all of the programmed remotes and keypads from the opener's memory. Once you have reset the learn button, you can try programming the remote or keypad again.
If you are still having trouble programming a remote or keypad, you can contact Chamberlain customer service for assistance. They will be able to help you troubleshoot the problem and get your garage door opener working properly.