Chamberlain Garage Door Remote Programming

Programming a Chamberlain garage door remote is a simple process that can be completed in a few minutes. Once you have programmed the remote, you will be able to open and close your garage door with the push of a button.

To program a Chamberlain garage door remote, follow the steps below:

Locate the Learn button on the garage door opener motor unit. The Learn button is usually located on the side or back of the motor unit.
Press and hold the Learn button for 2 seconds. The LED light on the motor unit will begin to flash.
Release the Learn button and press the button on the remote that you wish to program. The LED light will stop flashing and then flash again once.
Press the button on the remote a second time. The LED light will flash again once.
The remote is now programmed. Test the remote by pressing the button and observing that the garage door opens.

If you have multiple garage doors, you can program the remote to open and close each door. To do this, simply repeat the steps above for each door.

Here are some additional tips for programming a Chamberlain garage door remote:

Make sure that the remote is within range of the garage door opener motor unit.
If the remote does not program after you have followed the steps above, try replacing the battery in the remote.
If you are still having trouble programming the remote, you can contact Chamberlain customer service for assistance.