Chamberlain Garage Door Remote Keypad Programming

Chamberlain garage door openers provide convenience and security for homeowners. The remote keypad allows for easy access to your garage without the need for a key or remote control. Programming the keypad is a simple process that can be completed in a few minutes.

### Gather the Necessary Materials * Chamberlain garage door opener * Remote keypad * Ladder (if necessary) * Screwdriver (if necessary) ### Step-by-Step Instructions **1. Locate the Learn Button** * Identify the Learn button on the garage door opener motor unit. It is usually a small, round button labeled "Learn" or "Smart." **2. Position the Keypad** * Place the remote keypad near the garage door, within range of the opener motor. **3. Open the Keypad** * Open the keypad housing by removing the screws or by sliding the cover off. **4. Engage the Programming Mode** * Press and hold the Learn button on the garage door opener for about 3 seconds, or until the motor unit light flashes. **5. Enter the Access Code** * On the keypad, enter the desired 4-digit access code. Press the Enter key to confirm. * The motor unit light should stop flashing and remain solid. **6. Test the Keypad** * Exit the programming mode by pressing the Learn button again. * Enter the access code and press Enter on the keypad. The garage door should open. **7. Closing the Keypad** * Close the keypad housing and secure it with the screws or cover. ### Additional Notes * **Multiple Keypads:** You can program up to 3 remote keypads to a single garage door opener. * **Factory Default Code:** The factory default access code is 1234. It is recommended to change this code for security reasons. * **Clearing Keypad Codes:** To clear all programmed keypads, press and hold the Learn button on the garage door opener for about 10 seconds. * **Troubleshooting:** If the keypad does not work, check the battery, make sure it is within range of the opener, and ensure the correct access code is entered. ### Conclusion Programming a Chamberlain garage door remote keypad is a straightforward process that enhances convenience and security. By following these steps, homeowners can easily add keypad access to their garage door opener.