Chamberlain Garage Door Opener Remote Programming

Programming a Chamberlain garage door opener remote is a straightforward process that can typically be completed in just a few minutes. Follow these steps to program your remote:

Locate the
Learn
button on the back of the garage door opener motor unit. This button is usually red or orange.
Press and hold the
Learn
button for 2 seconds, or until the indicator light starts to flash.
Within 30 seconds, press and hold the desired button on your remote for 2 seconds. The indicator light will stop flashing when the remote is programmed.
Release the buttons and test the remote by pressing the programmed button. The garage door should open or close.

If the garage door does not respond to the programmed remote, try the following troubleshooting tips:

Check the batteries in the remote.
Weak or dead batteries can prevent the remote from transmitting a signal to the garage door opener.
Make sure the remote is within range of the garage door opener.
The signal from the remote can be blocked by obstacles such as walls or metal objects.
Try programming the remote again.
Occasionally, the programming process may need to be repeated to ensure a successful connection.

Programming Multiple Remotes

You can program up to 16 remotes to a single Chamberlain garage door opener. To program additional remotes, simply follow the steps outlined above for each remote.

Programming a Remote to Multiple Garage Doors

If you have multiple garage doors operated by the same Chamberlain garage door opener, you can program a remote to open or close all of the doors. To do this, follow these steps:

Press and hold the
Learn
button on the back of each garage door opener motor unit.
Within 30 seconds, press and hold the desired button on your remote for 2 seconds. The indicator light on each motor unit will stop flashing when the remote is programmed.

Now, when you press the programmed button on your remote, all of the garage doors will open or close simultaneously.

Erasing Remote Codes

If you need to erase the codes from all of the remotes programmed to your Chamberlain garage door opener, follow these steps:

Press and hold the
Learn
button on the back of the garage door opener motor unit for 6 seconds.
The indicator light will flash rapidly to indicate that all remote codes have been erased.

Now, all of the remotes will need to be reprogrammed before they can operate the garage door opener.