Chamberlain Garage Door Opener Programming Manual

Programming your Chamberlain garage door opener is a straightforward process that can be completed in just a few minutes. Follow these step-by-step instructions to ensure a successful programming experience.

Step 1: Gather Required Materials

Before beginning, ensure you have the following items:

Chamberlain garage door opener
Programming remote control or keypad
Stepladder (if necessary)

Step 2: Locate the Learn Button

The Learn button is typically located on the motor unit of the garage door opener. It is usually a small, round button with an LED light. On some models, the Learn button may be covered by a protective cover. Remove the cover if necessary.

Step 3: Put the Opener into Programming Mode

Press and hold the Learn button for 2-3 seconds. The LED light should flash, indicating that the opener is in programming mode.

Step 4: Activate the Remote Control or Keypad

Once the opener is in programming mode, press and hold the desired button on the remote control or keypad. The LED light on the opener should continue flashing.

Step 5: Wait for Confirmation

Hold the remote control or keypad button until the LED light on the opener stops flashing and remains solid. This indicates that the programming has been successful.

Step 6: Repeat for Additional Devices

If you have multiple remote controls or keypads, repeat steps 4-5 for each device you wish to program.

Step 7: Exit Programming Mode

To exit programming mode, simply press the Learn button again. The LED light should turn off, indicating that the process is complete.

Troubleshooting Tips

If you encounter any issues during programming, try the following:

Ensure the batteries in the remote control or keypad are fresh.
Check if the wiring connections to the opener are secure.
Try resetting the opener by unplugging it from the power outlet for a few minutes and then plugging it back in.
Contact a qualified technician if the issue persists.