Chamberlain Garage Door Opener Keypad Program

Programming a Chamberlain garage door opener keypad is a straightforward process that can be completed in just a few simple steps. However, it is important to note that the exact steps may vary depending on the specific model of keypad you have. If you have any questions, please consult your keypad's user manual before proceeding.

To program your Chamberlain garage door opener keypad, you will need the following:

Chamberlain garage door opener
Chamberlain garage door opener keypad
Phillips head screwdriver
Ladder (optional)

Once you have gathered your materials, follow these steps:

Prepare the keypad. Remove the cover of the keypad by unscrewing the screws. Locate the "Learn" button on the keypad. This button is usually located on the back or side of the keypad.
Prepare the garage door opener. Pull the emergency release cord to disconnect the garage door opener from the power. This will prevent the door from opening or closing while you are programming the keypad.
Put the garage door opener into programming mode. Locate the "Program" button on the garage door opener. This button is usually located on the back or side of the opener. Press the "Program" button and hold it down. The LED light on the opener will start to flash.
Press the "Learn" button on the keypad. The LED light on the keypad will start to flash. Release the "Learn" button.
Enter the access code. Enter the four-digit access code that you want to use to open the garage door. The LED light on the keypad will stop flashing and stay lit.
Press the "Program" button again. The LED light on the keypad will start to flash and then go out.
Test the keypad. Enter the access code into the keypad. The garage door should open.

Your Chamberlain garage door opener keypad is now programmed. You can now open your garage door by entering the four-digit access code into the keypad.

Here are some additional tips for programming your Chamberlain garage door opener keypad:

Make sure that the keypad is close to the garage door opener. The signal from the keypad can be weak if it is too far away.
If you have any trouble programming the keypad, consult your keypad's user manual or contact Chamberlain customer support.