Reset Garage Door Opener Liftmaster

If your Liftmaster garage door opener isn't working correctly, resetting it may solve the problem. Here are the steps on how to reset a Liftmaster garage door opener:

Locate the reset button.

The reset button is usually located on the back or side of the motor unit. It may be a small, recessed button or a push-button switch.

Press and hold the reset button.

Press and hold the reset button for about 5 seconds. The LED light on the motor unit will start to flash.

Release the reset button and wait for the LED light to stop flashing.

The LED light will stop flashing when the garage door opener has been successfully reset.

Reprogram the garage door opener.

Once the garage door opener has been reset, you will need to reprogram it. This involves entering the code for your remote control or keypad.

Here are some additional tips for resetting a Liftmaster garage door opener:

If the reset button does not work, you may need to disconnect the power to the garage door opener for a few minutes and then reconnect it.
If you are still having trouble resetting your garage door opener, you can consult the Liftmaster user manual or contact Liftmaster customer service.
Resetting the garage door opener will erase all of the codes for your remote controls and keypads. You will need to reprogram them after the reset.

By following these steps, you should be able to reset your Liftmaster garage door opener and get it working properly again.