How To Replace The Cable On A Garage Door

The cables on a garage door are responsible for lifting and lowering the door. Over time, these cables can become frayed or broken, which can prevent the door from operating properly. If you notice that the cables on your garage door are damaged, it is important to replace them as soon as possible.

To replace the cables on a garage door, you will need:
1. Two new garage door cables
2. Two new cable drums
3. A socket wrench
4. A pair of pliers
5. A stepladder
6. Safety glasses

It is important to note that the cables on a garage door are under tension, so it is important to take precautions when replacing them. Be sure to wear safety glasses and gloves, and follow all of the instructions carefully.

Step 1: Gather your materials and tools.

Step 2: Put on your safety glasses and gloves.

Step 3: Raise the garage door to its fully open position.

Step 4: Locate the two cables that need to be replaced. The cables are attached to the bottom of the garage door and run up to the cable drums at the top of the door.

Step 5: Use the socket wrench to loosen the nuts that hold the cables to the cable drums.

Step 6: Carefully remove the cables from the cable drums.

Step 7: Attach the new cables to the cable drums. Be sure to tighten the nuts securely.

Step 8: Lower the garage door to its fully closed position.

Step 9: Open and close the garage door several times to make sure that the new cables are working properly.

Replacing the cables on a garage door is not a difficult task, but it is important to follow all of the instructions carefully. By following these steps, you can safely and easily replace the cables on your garage door.