How To Install Garage Door Springs Cable

Garage door springs are an essential part of the door's operation. They provide the tension needed to lift and lower the door smoothly. If a spring breaks, the door will become difficult or impossible to open. In this article, we will provide step-by-step instructions on how to install a garage door spring cable.

Before you begin, gather the following tools and materials:

New garage door spring cable
Wrench
Screwdriver
Pliers
Step ladder
Safety glasses

Once you have gathered your tools and materials, follow these steps:

Safety first: Before you begin working on your garage door, disconnect the power to the door opener. This will prevent the door from opening or closing while you are working on it.
Prepare the door: Open the garage door manually and prop it open with a sturdy object like a 2x4.
Locate the springs: The springs are located on either side of the door, above the tracks. They are typically wound around a metal shaft.
Remove the old cable: Using a wrench, loosen the nuts that hold the cable to the springs. Then, use a screwdriver to remove the screws that hold the cable to the door frame. Finally, use pliers to cut the cable free.
Install the new cable: Feed the new cable through the holes in the door frame. Then, attach the cable to the springs using the nuts and bolts. Finally, tighten the screws that hold the cable to the door frame.
Test the door: Once the new cable is installed, close the garage door manually. Then, use the door opener to open and close the door several times. Make sure that the door operates smoothly and that there are no strange noises.

Installing a garage door spring cable is a relatively simple task that can be completed in about an hour.