Reset Code Chamberlain Garage Door Opener

Has your Chamberlain garage door opener started acting up? If so, you may need to reset the code. This is a relatively simple process that can be done in just a few minutes.

There are two ways to reset the code on a Chamberlain garage door opener: using the keypad or using the remote control. If you have the keypad, follow these steps:

Press and hold the "Program" button until the LED light starts flashing.
Enter the new 4-digit code.
Press the "Enter" button.
The LED light will stop flashing and the new code will be programmed.

If you don't have the keypad, you can use the remote control to reset the code. Follow these steps:

Press and hold the "Remote" button on the back of the remote control until the LED light starts flashing.
Press and hold the "Program" button on the garage door opener until the LED light starts flashing.
Release the "Program" button and then press the "Remote" button again.
The LED light will stop flashing and the new code will be programmed.

Once you have reset the code, you will need to reprogram all of your remote controls. To do this, follow these steps:

Press and hold the "Program" button on the garage door opener until the LED light starts flashing.
Press the button on the remote control that you want to program.
The LED light will stop flashing and the remote control will be programmed.

Repeat these steps for each remote control that you want to program.

If you have any problems resetting the code on your Chamberlain garage door opener, you can contact Chamberlain customer service for help.