Learn Button On Liftmaster Garage Door Opener

The learn button on a LiftMaster garage door opener is a small, usually red, button located on the motor unit or wall-mounted control panel. This button is used to program new remote controls or keypads to the opener. When pressed, the learn button puts the opener into programming mode, which allows it to receive and store the codes from the new devices.

To program a new remote control or keypad to your LiftMaster garage door opener, follow these steps:

Locate the learn button on the motor unit or wall-mounted control panel.
Press and hold the learn button for 2-3 seconds, or until the LED light on the opener starts to flash.
Within 30 seconds, press the button on the new remote control or keypad that you want to program.
The LED light on the opener will stop flashing and remain lit, indicating that the new device has been programmed successfully.

You can program up to 16 remotes or keypads to your LiftMaster garage door opener. If you need to erase all of the programmed devices from the opener, simply press and hold the learn button for 6-7 seconds. The LED light on the opener will flash rapidly, indicating that all of the programmed devices have been erased.

Here are some additional tips for programming your LiftMaster garage door opener:

Make sure that the new remote control or keypad is within range of the opener when you are programming it.
If the LED light on the opener does not flash when you press the learn button, check to make sure that the batteries in the remote control or keypad are fresh.
If you are having trouble programming a new remote control or keypad, you can contact LiftMaster customer service for assistance.

The learn button on a LiftMaster garage door opener is an important feature that allows you to easily add new remote controls or keypads to your system. By following the steps above, you can quickly and easily program your opener to work with your desired devices.