Double Garage Door Spring Replacement

Torsion springs are used to counterbalance the weight of a garage door and make it easy to lift. They are mounted on a steel shaft above the door opening and are typically made of oil-tempered steel. Torsion springs come in a variety of sizes and strengths, depending on the weight of the door they are designed to support.

Over time, torsion springs can weaken and break, especially if they are not properly maintained. A broken torsion spring can make it difficult or impossible to open the garage door, and it can also be dangerous if the door falls suddenly.

If you think that your garage door springs may be broken, it is important to have them replaced as soon as possible. Replacing torsion springs is a complex and dangerous task that should only be performed by a qualified professional.

Here is a step-by-step guide to double garage door spring replacement:

Safety first. Before you begin working on your garage door springs, it is important to take some safety precautions. Wear gloves and safety glasses, and make sure that the garage door is disconnected from the power supply.
Locate the torsion springs. Torsion springs are typically located above the garage door opening, on a steel shaft. They are usually painted black or silver.
Determine the type of torsion springs you need. There are two types of torsion springs: extension springs and torsion springs. Extension springs are used on doors that are less than 7 feet tall, while torsion springs are used on doors that are 7 feet tall or taller.
Purchase the correct replacement springs. Once you know the type of torsion springs you need, you can purchase them from a hardware store or a garage door supply company.
Remove the old torsion springs. To remove the old torsion springs, you will need to use a pair of spring pliers. Carefully grip the spring with the pliers and slowly release the tension. Once the spring is fully released, you can remove it from the shaft.
Install the new torsion springs. To install the new torsion springs, simply reverse the steps that you used to remove the old springs. Start by placing the spring on the shaft, and then use the spring pliers to tension the spring. Make sure that the spring is fully tensioned before you release the pliers.
Reconnect the garage door to the power supply. Once the new torsion springs are installed, you can reconnect the garage door to the power supply. Test the door to make sure that it is working properly.

Replacing torsion springs can be a complex and dangerous task, but it is important to have them replaced if they are broken. By following these steps, you can safely and easily replace the torsion springs on your garage door.