How To Reprogram A Liftmaster Garage Door Opener Keypad

Reprogramming a LiftMaster garage door opener keypad is a simple process that can be completed in a few minutes. By following these steps, you can easily change the access code for your garage door and ensure that it is secure.

Materials You'll Need

* LiftMaster garage door opener * Keypad * Phillips screwdriver * New access code

Step 1: Remove the Keypad

* Locate the keypad on the wall next to your garage door. * Use a Phillips screwdriver to remove the two screws that hold the keypad in place. * Carefully pull the keypad away from the wall.

Step 2: Locate the Programming Button

* Once the keypad is removed, you will see a small black button on the back of the unit. This is the programming button.

Step 3: Press and Hold the Programming Button

* Press and hold the programming button for about 5 seconds. The LED light on the keypad will start to flash.

Step 4: Enter the New Access Code

* While the LED light is flashing, enter the new access code that you want to use. The access code must be between 4 and 8 digits long. * Once you have entered the new access code, the LED light will stop flashing.

Step 5: Reattach the Keypad

* Carefully align the keypad with the two screw holes on the wall. * Insert the two screws and tighten them until the keypad is securely in place.

Step 6: Test the New Access Code

* Enter the new access code on the keypad. The garage door should open. * If the garage door does not open, repeat steps 1-5.

Tips

* If you have multiple LiftMaster garage door openers, you can use the same access code for all of them. * You can change the access code for your garage door opener keypad as often as you like. * If you lose the access code for your garage door opener keypad, you can reset it to the factory default code. The factory default code is usually 1234.